Відмінності між версіями «Danger-Shield Bausatz»

Поточна версія на 20:53, 11 травня 2015

Das Danger Shield ist ein Aufsatz für die Arduino Boards mit einer Menge nützlichen Funktionen.

Wir bekommen immer wieder die Frage: "Was macht man mit den Danger Shield?"

Was du damit machst bleibt dir überlassen, es hat zahlreiche Funktionen.

The Danger Shield mounts on top of your Arduino or Arduino Pro and equips it with a variety of fun and useful inputs and outputs. The Danger Shield has so much potential; we can’t wait to see what you’re able to do with it! The shield’s features include:

Three linear slide potentiometers connected to the Arduino’s analog pins 0 through 2.

Red and yellow LEDs connected to digital pins 5 and 6 - PWM pins - so you can easily vary their brightness.

Three momentary push buttons connected up to the Arduino’s digital pins 10 through 12. Those lines will go low when the buttons are pressed.

A photocell and a temperature sensor, both with analog outputs, are connected to the analog pins 3 and 4, respectively.

An 8-bit shift register set up to control a blue 7-segment LED.

A buzzer - so you can get sound out of your Arduino

Capacitive Touch pad - Using the CapSense library to sense touch.

This product comes as a kit of parts, which you’ll have to solder into the included PCB. All parts are through-hole so it should go together relatively easily; but always check your component orientation before soldering!